Welcome to the Growery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!
mines in my tent so if my tent is zipped up I dont hear it at all, my bedroom is in the room next door and I dont hear it over my room fan.
I leave my filter/blower run 24/7 and only notice the volume when Im feeding/in the tent.
just keep the prefilter/dust cover clean
I just stood my filter up in a corner of my tent and set the blower right on top then ran the flex vent tubing up to my light and then another section from the light out of the tent to where ever your venting your hot air. no vibrations or extra noise from that unit. sounds like a hair dryer a bit.
Is that you 13? LOL, good to see you here. I am a late arrival.
I wondered if you might get better heat transfer if you hung the filter higher in the tent. This is what I intend to do.
Take care,
JD
its me Omicron
the blower I have blows almost all the heat that comes of the light right out the vent. I just need to figure out how to cool the room during the hot summer months or I just dont grow during those times.
Quote: hawksapprentice said: It's called an air conditioner.
to much power used on 1 circuit, I keep tripping breakers if I use an A/C unit. only 1 outlet and its alreay got my 1000w light/ballast/fan and carbon filter/blower plugged into it..
cant run extension cords to the room or it will give away the stealth effect.
I already drilled a hole through the floor to run 1 extension cord down to my basement to plug in on a diff circuit. cus when both my veg light and flowering lights would both turn on it was too much load. pop!
2 diff rooms share the same dividing wall and outlet.