Welcome to the Growery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!
|
 Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
 DeathByAstonishmnt
Stranger
Registered: 11/07/18
Posts: 5
Last seen: 6 years, 4 months
|
 Noob-friendly CBD/oil extraction process? 
#834626 - 11/07/18 10:19 AM (6 years, 4 months ago) |
|
|
Hello,
Apologies if this is covered somewhere, I didn't see it in the site pages or any stickied teks.
I've been using medicinal indica oil for a while and it's been really helping; but I'm barely making ends meet and need to cut every cost possible.
From what I see, many of the teks use solvents and are focused on THC extraction specifically; I mostly need the CBD's, whether or not THC is also extracted is not important to me.
Can anybody recommend a process that:
(1) doesn't use chemical solvents (everclear or 70%/95% isopropyl is OK)
(2) Has decent CBD extraction
(3) Is noob-friendly
Thanks!
|
DeathByAstonishmnt
Stranger
Registered: 11/07/18
Posts: 5
Last seen: 6 years, 4 months
|
Re: Noob-friendly CBD/oil extraction process? [Re: yoosername]
#834633 - 11/07/18 01:48 PM (6 years, 4 months ago) |
|
|
Thank you both for the responses.
I get page not found for that URL, but found more results here using "RBO" and "QWET" keywords.
These teks seem to yield a concentrated resin, where what I was taking was oil with what looked like finely ground plant matter from a dropper. I didn't taste any hint of alcohol, so I'm guessing it was not actually an extract nor tincture, just ground up weed in olive oil? 
Now I'm a bit concerned about getting a consistent dosing. I'm thinking to;
- Do the QWET tek to get resin
- Draw X cc of heated resin into each syringe
- Draw Y cc of heated coconut oil into each syringe
- Leave enough air in the syringe to mix well, then push out the air and store syringe in the fridge
I'm thinking as long as the same strain is used and resin : coco-oil ratios are maintained, dosing should be pretty consistent between "batches?"
|
DeathByAstonishmnt
Stranger
Registered: 11/07/18
Posts: 5
Last seen: 6 years, 4 months
|
Re: Noob-friendly CBD/oil extraction process? [Re: Rider420]
#834664 - 11/09/18 10:05 AM (6 years, 4 months ago) |
|
|
Thanks for the comments and great video! Exactly what I needed.
| |
|
|
Threaded
Previous
Index
Next
Edit 
Reply 
